MR Calcium Silicate Pipe Insulation
PT Tali Rejeki supplies MR Calcium Silicate Pipe for hot piping insulation. Choose a diameter and thickness, then contact Sales for a quotation.
Product description
MR Calcium Silicate Pipe is a calcium silicate pipe covering for hot piping insulation. Each section is 610 mm long; the number of segments per set depends on the diameter.
The MR data sheet lists a maximum service temperature of 650°C and maximum density of 220 kg/m³. Choose the diameter and thickness for your installation.
Product selection and use guide
MR Calcium Silicate Pipe Insulation is calcium silicate insulation selected according to its pipe-section or board form. The pipe form follows the circumference of the insulated line.
How to choose
Measure equipment geometry and specify layer thickness, joints and supports. Check properties and service conditions in the exact type data sheet. Measure the actual outside diameter; nominal pipe size is not always the outside diameter. Specify insulation thickness and details for elbows, valves and supports.
Applications to consider
Consider calcium silicate pipe sections for industrial thermal pipe runs designed for rigid insulation.
Use limitations
Rigid material cannot be wrapped like blanket. Plan protection against water and mechanical damage; a similar name does not make it a ceiling board.
Pre-order checklist
- Send pipe diameter or surface dimensions, thickness and required length.
- Include joint, fastening and protective jacketing details.
- Send the outside diameter, line length, fitting count and required thickness.
Frequently asked questions
Can calcium silicate pipe sections bend around an elbow?
Do not force rigid material. Plan cuts or fittings for the pipe route detail.
Can calcium silicate pipe insulation become wet?
Check water protection and jacketing closure requirements; do not leave wet conditions unevaluated.
Does a rigid pipe section carry the pipe load?
Rigidity alone does not establish this. Verify pipe load and support details separately.
Is nominal pipe size enough to select pipe insulation?
Not always. Match the pipe outside diameter to the insulation inside diameter to avoid a loose or forced fit.
This guide supplements the original description; it does not replace technical data sheets or project design. Match the type and dimensions to the product specifications and obtain written confirmation for special requirements.